Como se Configura El Dwell De Una Ion

Buena.. Yo Quiero Saber Como Se Configura El Dwell De Una Ion

en el manual te dice!



http://www.smartparts.com/Manuals/Ion_Manual.pdf





The dwell setting determines how long the Ion holds open its solenoid valve, which ultimately affects
how much gas is released to fire each shot. It is important to balance the dwell and the operating pressure
(the setting of the vertical regulator). Too high of a dwell with a low operating pressure will cause
poor gas efficiency and velocity drop-off. Too low of a dwell will leave the marker unable to properly
cycle through a full firing sequence. Dwell adjustment should be performed after changing internal components
such as the bolt or installation of a quick exhaust valve (QEV.) Dwell setting changes should not
be used to adjust velocity.
The dwell value can be adjusted between 8 milliseconds (1ms = 0.001 seconds) and 52ms in 0.5ms
increments. To adjust the dwell, make sure the marker is already turned on, select the proper adjustment
mode for Dwell Up or Dwell Down and press the power button once for every .5ms change desired.
To optimize your dwell setting, wear proper paintball protective goggles and gas up your Ion with a barrel
blocker in place, with no paint or hopper. Turn on the Ion and press the power button once to de-activate
Vision mode. Decrease the dwell time (solid red adjustment mode) until the Ion can no longer complete
a full firing cycle (bolt does not close all the way) each time you pull the trigger. Increase the dwell value
(solid yellow adjustment mode) one button press at a time, test firing after each change until you hear the
Ion fire a full volume shot. Increase the dwell by an additional 15 to 20 button presses to reach the setting
for best gas efficiency.If your new setting causes an increase in first shot drop off, where the marker is at rest for an extended
period of time and has reduced velocity or will not fire on the first shot but fires fine after that, first
disassemble, clean and lubricate the Ion bolt assembly and repeat the dwell setting procedure.
If this does not eliminate the problem, further increase the dwell setting until there is no longer a sluggish
first shot.

ahora ke board tu tienes?

el Normal

miralo ahy pedro te dio la repuesta!

Soto escribió:miralo ahy pedro te dio la repuesta!

pero el me pregunta que board yo tengo.

Si tienes el manual ahy te explica como hacerlo.

-En el link es el manual.

- Y te pregunto ke board tienes por si acaso, ya se tienes diferentes Configuraciones.